Skip to content

One-rep max and training percentages

Your one-rep max (1RM) is the most you can lift once with good form. You don't have to test it to use it: a hard set of a few reps gives a good estimate.

By Utility Empire · Updated November 19, 2026

Work out your own

Estimating your 1RM from a set

Take a weight you can lift for 3 to 10 clean reps, do as many as you can with good form, and put the weight and reps into a formula. The two most used are:

  • Epley (1985): 1RM = weight × (1 + reps ÷ 30)
  • Brzycki (1993): 1RM = weight × 36 ÷ (37 − reps)

100 kg for 5 reps gives 116.7 kg with Epley and 112.5 kg with Brzycki. At 10 reps the two agree: 225 lb for 10 gives 300 lb with both. Estimates get less reliable past about 10 reps, so a heavier set gives a better answer.

What each percentage means

Turn the formulas around and you get how many reps you can expect at a given share of your max:

Reps to failureEpleyBrzycki
1100%100%
293.8%97.2%
390.9%94.4%
488.2%91.7%
585.7%88.9%
683.3%86.1%
878.9%80.6%
1075.0%75.0%
1271.4%69.4%

Training programs use these percentages to set weights. Heavy strength work usually sits above 85% for sets of 1 to 5. Muscle-building work often sits around 65 to 85% for sets of about 6 to 12, and lighter weights work too when sets are taken close to failure. People differ: some can do many more reps at 75% than others, especially on lower-body lifts.

Loading the bar

Once you know the weight, the plate calculator shows which plates go on each side, for a 20 kg, 15 kg or 45 lb bar.

Comparing lifters of different sizes

Heavier lifters lift more, so powerlifting compares them with a bodyweight score. DOTS is the current standard in many federations; the older Wilks score is still widely quoted. Both multiply your total by a coefficient from your bodyweight and sex, so a 70 kg and a 110 kg lifter can be ranked on one scale.

Testing a true max safely

If you do test a real 1RM, warm up with gradually heavier singles, use safety bars or spotters, and stop when your form slips. For most training, an estimate from a hard set of 3 to 5 is all you need.

Sources

  • Epley B. Poundage Chart. Boyd Epley Workout. Lincoln, NE: Body Enterprises; 1985.
  • Brzycki M. "Strength testing: predicting a one-rep max from reps-to-fatigue."J Phys Educ Recreat Dance 1993;64(1):88-90.
  • Schoenfeld BJ, Grgic J, Van Every DW, Plotkin DL. "Loading recommendations for muscle strength, hypertrophy, and local endurance: a re-examination of the repetition continuum."Sports 2021;9(2):32.
  • OpenPowerlifting: the DOTS and Wilks coefficients our DOTS calculator uses.